Care and Maintenance Instructions
To keep your dirt disposal running at peak performance, follow these
care procedures:
Dock Part Care Frequency Replacement frequency
Bags
-
Bags should be replaced
when prompted by the LED
indicator/app
Charging Contacts
IR Window
Once every month
-
Blower Cover
inside canister
Once every month (remove
debris from blower cover)
-
Care and Maintenance
Note: iRobot manufactures various replacement parts and assemblies. If you
think you need a replacement part, please contact iRobot Customer Care for
more information.
Note: Do not
spray cleaning
solution directly
onto sensors
or into sensor
openings.
Cleaning the IR Window
and Charging Contacts
Inspect the sensors
and charging contacts
to make sure they are
clear of debris. Wipe
with a clean, dry cloth.
Removing Debris
from Blower Cover
Inspect blower cover
for any lint or debris
built-up, and wipe
with a clean dry cloth
to remove.
Note: To achieve optimal performance
with your robot and automatic dirt
disposal, clean and/or replace your
robot’s filter as needed.
Install a new bag, sliding the
plastic card into the guide rails.
Discard the used bag.
Press down on the lid making
sure it is completely closed.
4
3
5
Note: This will
seal the bag so
dust and debris
cannot escape.
Replacing the Bag
Pull up on the plastic card to remove
the bag from the canister.
Lift up on the canister lid to open.
1
2
To Previous Page
Loading...
Need help?
General
