IRONEDGE XEBEX - Xebex Treadmill Console Modes; Standby Mode; Sleep Mode; Pause Mode

5
XEBEX TREADMILL
CONSOLE MODES
Once the batteries are installed into the console, the console will turn on ash Figure 1
nd enter STANDBY mode as depicted in Figure 2.
“PRESS START” will be displayed on the screen. STANDBY Mode will automatically
time out after ten (10) minutes without activity and the console will turn off.
1. Standby Mode
Figure 1
Figure 2
SLEEP Mode: After ten (10) minutes of inactivity, the console
will automatically enter SLEEP mode, Depicted in gure 3.
2. Sleep Mode
Figure 3
During a workout or program, press the START key to enter into
PAUSE mode. The display will read “PAUSED” as depicted in Figure
4. To return to the previous program, press the START key again.
3. Pause Mode
Figure 4
END Mode: Press the STOP key to end a program and Enter END mode. The console will
display summary metrics of your workout. Summary metrics are displayed on three outputs that
loop twice before the console will return to STANDBY mode. Summary metrics three outputs
displayed in Figure 5:
a. RESULTS: Total time, Total Distance, and Total Calories
b. MAX: Maximum Watts, Speed, RPM, and Heart Rate**
c. AVE: Average Watts, Speed, RPM, Pace, and Heart Rate**
**Heart Rate will only be displayed if wearing a compatible heart rate monitor
4. End Mode
Figure 5