16
4.1.1 Local time (T1)
Press until the day (3 letters, below the minutes) appears on the display.
To switch the key tone on/off
This brings you to the time set mode.
The element to be set will start to blink and a text will appear, in English,
informing you of what needs to be set.
If during setting for longer than one minute no button is pressed,
the watch will automatically leave the set mode. The settings made up
to this point will be stored.
The commands for setting the time are as follows:
With these buttons you change the setting value
Skip to the next setting value (until you leave the set mode)
Leave the set mode. The settings made up to this point will be stored.
To Next Page
Loading...