IROX iClimber-DCX - 4.3.2 PEER Settings

To Next Page

To Previous Page

4.3.2 PEER Settings

To log the existing PEERS in the system (PAIRING) and to carry out the

calibrations/settings of the FOOT PEER and the HEART PEER, the stopwatch must

be on 0:00:00.

Entering the PEER calibration/setting mode:

--► You thus enter the setting menu for the PEER functions.

The menu ‘PAIR DEVICE’ is displayed first.

--► You thus enter the next setting menu after the following procedure:

PAIR DEV. -->S/R--> CALIB FOOTPEER -->S/R--> SET ZONE -->S/R-->

VERTICLOG -->S/R--> PAIR DEV. -->S/R --> etc.

VERTIC-LOG: see Chapter 4.3.1

--► You thus enter the setting mode of the function that is shown on the

display (functions: PAIR DEV. or CALIB FOOTPEER

or SET ZONE)

--► Exit setting mode and back to stopwatch.

If no key is pressed for around one minute, the system automatically exits

the setting mode and returns to the stopwatch.