What to do if some valves don’t operate in my Irritrol Rain Dial Plus 9?
If some valves in your Irritrol Irrigation System aren't working, the issue might stem from a defective solenoid or a loose wire connection. Test the solenoid and replace it if necessary. Ensure all wire connections are secure and check for continuity.
General| Brand | Irritrol |
|---|---|
| Model | Rain Dial Plus 9 |
| Category | Irrigation System |
| Language | English |
Guidance on locating and physically mounting the indoor and outdoor controller units.
Instructions for wiring the valve solenoids to the controller terminals.
How to connect the power source for indoor controller models.
How to connect the power source for outdoor controller models.
How to set watering days using specific days, skip days, or odd/even.
Step-by-step instructions for setting the controller's current time.
Step-by-step instructions for setting the controller's current date.
Guide to setting up automatic watering schedules.
How to set daily watering days for a program.
How to set watering intervals using the Skip Days feature.
How to set watering days using the Odd/Even schedule.
How to set multiple start times for a program.
How to set the run duration for each valve.
Diagnosing and fixing issues where some valves fail to operate.
Troubleshooting steps when no valves operate at all.
Resolving issues with watering occurring at incorrect times.
Interpreting and resolving 'FUS' error display (short circuit).
To Next Page
