TROUBLESHOOTING
No Power
Check and make sure whether the fuse is blown,
replace fuse with proper value if necessary.
Some errors occur
in
the LCD or no function when
pressing the button.
Turn off the unit and restart the unit again. Use
Factory Default Restart.
Poor radio reception
or
static.
Antenna
may
not be the proper length. Make sure
the antenna is fully extended. Antenna
may
be
broken. Replace antenna.
The broadcast signal is too weak.
The antenna is poorly grounded. Check and make
sure the antenna is properly grounded at it's
mounting location.
Disc cannot be loaded
Disc is loaded
in
the machine. Clear the disc by
pressing eject
No Picture.
The Video line from the main unit to the
TV
is
not
connected properly. Check connections.
Improper setting
of
the
TV
SYSTEM. Set the
TV
SYSTEM to "NTSC", according to the
connected television.
18
Disc error appears.
The disc may be damaged
or
dirty.
Clean disc and retry.
When there is no color on video.
Turn off the unit and restart the unit again.
Use Factory Default Restart.
FACTORY DEFAULT RESTART
Press and hold POWER button for 5 seconds - Unit will
shut off. Restart unit by pressing the ON button. Factory
defaults will be reset with this type
of
restart.
NOTE:
If
any
of
the problems persist after check list has been
made, consult your nearest service dealer.
Never attempt to disassemble your unit by yourself.
To Next Page
