29
STEP 7
STEP 6
STEP 5
STEP 4
Adjust the front edge of the lm to align with the outer roller, as shown in the
picture at the right. Adjust the white lm roll guide if necessary. Loosen the
knob and slide the guide so it lightly touches the lm core. Tighten the knob.
The guide should touch but not bind the roll.
Lower the lm loading arm. Fold back any excess lm and place it inside
the machine. Close the lm cover.
Raise the lm loading arm, as shown in the picture at the right. Thread the lm
behind the arm. Pull approximately 150mm (6 inches) of lm past the arm.
Adjust the rear white lm roll guide if necessary. Loosen the knob (accessed
from inside the machine) and slide the guide so it almost touches the lm
core. Tighten the knob. The space between the guide and lm core should
be very small: 2mm (1/16 inch).
To Next Page
Loading...