6
- Once you install and place the machine, please do not remove the
jacks. Since there are casters on the stand, it may move during
operation. In addtion, if the jacks are not xed the wrapping
performance is reduced.
- Please use single phase 200V to 240V
- Please connect to a proper circuit that matches the specic plug
with the earth ground for this machine.
A power supply with uctuating voltages can damage the machine
or cause operation problems.
- Please do not step on the power cable or put heavy things on it.
It can damage the cable and cause accidents or trouble.
POWER SUPPLY
Jacks for xing the machine location
To Next Page
Loading...