iSimple TranzIt USB IS32

Questions and Answers

N
Nathaniel YoungJul 27, 2025
Why do I hear noise/static when using iSimple TranzIt USB IS32?
- D
  Diana Johnston DDSJul 27, 2025
  Noise or static can occur due to a few reasons. First, ensure that you've tuned your radio to the exact frequency specified on the side of your iSimple TranzIt™USB interface. Second, a local radio station might be interfering. If this is the case, try switching the frequency setting on the side of the TranzIt™USB to the alternative position and tune your radio to this new frequency.
A
Andre RossAug 4, 2025
What to do if there is no audio from the Aux source with iSimple TranzIt USB IS32 USB Interfaces?
- N
  Nicholas RiversAug 4, 2025
  If you're not getting any audio, here are a few things to check: * Make sure the TranzIt™USB is powered on by pressing the Power Button. * Verify that all connection cables are properly connected. * Ensure that your FM radio is tuned to the correct frequency, which is indicated on the side of the interface.
P
popeamandaAug 12, 2025
Why is my iPod/iPhone not charging with iSimple TranzIt USB IS32?
- J
  Justin GutierrezAug 12, 2025
  If your iPod/iPhone isn't charging, there are a couple of potential causes: 1. Check that the power connection on the TranzIt™USB is properly connected. 2. The fuse in the power plug on the docking cable might be blown. Inspect the fuse and replace it with an equivalent fuse if necessary.
J
jessicamirandaAug 18, 2025
How to fix low audio from iSimple TranzIt USB IS32?
- A
  Ashley OwensAug 18, 2025
  If you're experiencing low audio, try these solutions: First, increase the volume on your audio source. Second, adjust the gain setting located on the back of the TranzIt™USB to a higher level.