ww w.islabikes.co.uk
Rear wheel removal
Your eJoni bicycle uses a rear hub motor which consequently requires a
slightly dierent procedure for removing the rear wheel:
Ensure that the electronic system is switched o via the iWoc
Trio controller.
You must always disconnect the motor cable before doing any
maintenance or servicing work on the rear of the bicycle. Failure to
do so is highly likely to result in serious injury!
1. Shift into the smallest sprocket on the cassette.
2. Undo the rear axle nuts using an 8mm allen key and remove the
location washers.
3. Pull wheel down from dropouts.
OK
To Next Page
Loading...
