ADDING ADDITIONAL SENSORS AFTER THE INSTAL-
LATION
1. Remove the insulation tags from new sensors.
2. Launch iSmartAlarm app and go to the Security page.
3. Select the Safety Monitor tab.
4. Pull the Safety Monitor page down to view the “Add Sensor” button.
5. Press the “Add Sensor” button to start the adding sensor process.
6. After the sensors are found, press the “Add” button to add them to the system.
APP – BASIC WALKTHROUGH
Upon download and installation of App on your phone, you will be required to
complete some basic necessary steps to begin using your iSmartAlarm. The basic
overview of steps are as follow:
1. Sign up, following prompts, with accurate information.
Please ensure that you provide your phone number
which will be used as the alert phone number when
the system is set off.
14
To Next Page
Loading...
Need help?
General
