iSmartAlarm CubeOne User Manual

3. LED flashes red once when batteries are installed.
Note: Whenever removing and/or replacing batteries, you should wait at least ten
seconds before placing new batteries in the sensor and powering on the device. This
will allow the sensor's residual power charge to cycle through.
Remote tag:
How to change battery:
1. Unscrew and take off the back lid.
2. Replace the button battery with same type - CR2032.
3. LED flashes red once when the battery is installed.
Note: Whenever removing and/or replacing batteries, you should wait at least ten
seconds before placing new batteries in the sensor and powering on the device. This
will allow the sensor's residual power charge to cycle through.
5

iSmartAlarm CubeOne Specifications

General

Brand	iSmartAlarm
Model	CubeOne
Category	Security System
Language	English