To Next PageTo Next Page
Need help?Do you have a question about the Isotemp Basic and is the answer not in the manual?
General| Material, outer shell | Polypropylene |
|---|---|
| Insulation | Polyurethane foam |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Thermostat | Adjustable |
| Pressure resistance | 6 bar |
| Connections | 1/2" |
| Capacity | 15, 30, 50 l |
Use non-corrosive fittings like brass or stainless steel for water heater connections.
Use heat-resistant, pressure-approved hoses for engine and fresh water connections.
Drain tank for freezing risk and remove power cord for longer periods.
Turn power off, drain tank, then reset overheat protection by pushing the pin.
Technical specifications for the Basic model series, including volume, weight, and heater options.
Technical specifications for the Slim/B model series, including volume, weight, and heater options.
Technical specifications for the Slim Square model series, including volume, weight, and heater options.
