You can use the external ashes with the following modalities:
With OPTICAL FIBER
Two ber optic connectors are present on the housing top with standard “Sea & Sea”
tting. In this case you have to use the bushings for optical ber placed on the top.
Pass the optical ber cable of the ash in the specic space on the bushing.
With Optical Fiber you have to use pull up ash of the camera.
HOW TO CHANGE BATTERY
To remove the battery, use a small athead screwdriver to lift up the battery.
Install a CR2450 battery into the battery compartment inside the front housing.
With SYNCRO CORDS
Strobes from SEA&SEA, INON, IKELITE and Subtronic must be used in Manual
power modes when connected via electrical sync cord.
An internal electric circuit controls the two syncro cords by means of 3 switches.
If the switch is positioned on [ON] it will be possible to work with the ash in manual
or TTL mode as indicated in the gure below:
N.B. this is also necessary in case of any troubles when using syncro cords with
the strobe in manual mode.
USING THE FLASH
ON
MANUAL or TTL MANUAL or TTL
1 2 3 4
ON
1 2 3 4
18
To Next Page
Loading...