inlet pressure is lower than 20 psi, a booster pump must be installed at the water inlet pipe of the
water purifier to ensure the working pressure meets technical requirements.
Before connecting the water inlet pipe, remove any remaining impurities and dust in the pipe and
close the main water supply before connecting it.
While connecting pipes, keep the pipes as close to the wall as possible. The routing of the pipes
should be straight, and the corners should be clear. The pipes should be fixed on the wall after
installation.
When connecting screw parts, seal rings are generally installed. Please be aware that excessive
force may cause the threads to slip and the screw to crack.
Connect the hose to the brine suction port on the control valve, connect the other end to the brine
valve, tighten the nut, and ensure that all connections are tight to prevent leakage.
During installation, pay attention to the direction of water flow, connect the inlet and outlet pipes
according to the inlet and outlet signs, and ensure there is no water leakage after installation.
The installation and commissioning of all machines can be conducted by common users or a
professional technician.
www.123filter.com | (678) 261-7611 | support@123filter.com Page 10
To Next Page
Loading...
Need help?
General
