Ispring WCS45KG User Manual

WCS45KG Whole House Central Softener Operation
(1) Product Functions and Features
iSpring’swhole house central softeners not only providefeatures such as large water output, optimal
water softening, and stable performance, but they can also be fully automatic and intelligent in
operation, automatic regeneration, and dynamic salt dissolution. In addition, these softeners not
only meet the needs of household bathing, laundry, cleaning, water heaters, water heaters, etc., but
they also provide softened water for businesses, institutions, hospitals, schools, and other
enterprises.
Using municipal tap water as the source, these products,after cation-exchange resin treatment,
remove cationsfrom the water, such as calcium and magnesium, and have the following
characteristics:
• Fully Automatic Control
• A built-in time controller, twenty-four-hour time control. Based on the set number of interval
days or the amount of treated water, the filter material is cleaned at the set regeneration time
(usually in the early morning before any use).
• The control system can calculate and design an economical and effective soft water treatment
plan based on the water source and the treated water volume.
• The regeneration cycle can be set based on time or treated water volume.
• Users can arbitrarily set the start time of the regeneration process.
• Cycle function programming
Service: After the source water flows through the water softener at an absolute pressure and
flow rate, the Na
+
in the ion exchange resin exchanges with Ca
2+
, Mg
2+
, and other cations in the
water to reduce the concentration of Ca
2+
and Mg
2+
ions, thereby softening the water quality.
Backwash: After the ion exchange resin is saturated, it must be backwashed before regeneration.
The purpose here is to wash away the suspended, retained, agglomerated impurities on the resin
surface, along with removingany broken resin. The other purpose is to loosen the compressed
resin layer, which is beneficial to the regeneration of ion exchange resin.
Brine: The salt solution, with a specific concentration and flow rate, flows through the entire
ion exchange resin layer to regenerate the saturated resin and restore the original softening,
exchange capacity.
Rinse: Removes any remainingbrine between the resin and wash until the water is qualified;
presses the resin layer tightly to achieve a high-quality softening effect.
Refill: Replenish the brine tank with water that dissolves the salt for regeneration to produce a
saturated brine for the next regeneration.
• Produce a saturated brine with uniform concentration
The brine tank's water is replenished from bottom to top, and the brine settles from top to bottom
by natural convection, evenly mixing the brine until it reaches a saturated state.
www.123filter.com | (678) 261-7611 | support@123filter.com Page 20

Ispring WCS45KG Specifications

General

Brand	Ispring
Model	WCS45KG
Category	Water Dispenser
Language	English