(6) Press and hold "↑" and "↓"at the same time for 3 seconds, then press "SET/REGEN" to
enter the following user menu settings:
UNIT SIZE:
The “RESIN VOL.”is the amount of ion exchange media used in
the system.
CYCLE SETTINGS (BACKWASH, BRINE, RINSE):
The system has pre-engineered default settings for every
valvemode, unit
size, and salt setting. The settings are
optimized to maximize salt and water use efficiency. The
settings can be manually adjusted. Users can adjust these
parameters at any time with the help of an application engineer
based on the water environment. Refi
calculated.
LOCK VALUE:
This setting locks the value set in the previous page, and the
end user will not be able to modify it before the setting is
changed to UNLOCK.
Page 19 www.123filter.com | (678) 261-7611 | support@123filter.com
To Next Page
Loading...
Need help?
General
