iStorage DATASHUR SD - Introduction and Initial Setup

4
First Time Use / Admin PIN setup
1. Insert a genuine iStorage MicroSD card
into the datAshur SD card slot.
The datAshur SD may need to be
charged before use for 20-30 minutes
by inserting into a powered USB port.
The datAshur SD drive is supplied in the
‘Initial Shipment State’ with no pre-set
Admin PIN. An 8-64 digit Admin PIN
must be created before the drive can be
used as set out below under ‘First Time
Use / Admin PIN setup’.
PIN Requirement:
• PINs must be a minimum length of 8 and
a maximum of 64 digits.
• Cannot contain all sequential numbers
(23456789 or 98765432).
• Cannot contain all repeating numbers
(11111111).
To congure an Admin PIN and unlock
the datAshur SD for the rst time, please
follow the simple steps in the table below.