WARRANTY TERMS AND CONDITIONS
1.0 In the event that Goods supplied are defective in that they have a defect
that existed at the time of delivery, HMI shall (at its option) meet the cost
of replacing or repairing such defective Goods or part thereof subject to the
following:-
1.1 Labour costs will be paid in accordance with HMI’s standard repair times
and standard rates, which are agreed upon before work is carried out.
1.2 HMI has the sole discretion to determine whether the Goods shall be
returned to HMI’s premises or repaired at any other location, which HMI
may nominate.
1.3 HMIwillpayforlubricatingoil,coolantconcentrate,lterelements,belts,
hoses, gaskets and other maintenance items that are not reusable due to
such defect. (at its discretion)
1.4 Only distributors, dealers or workshops authorized by HMI may carry out
warranty repairs.
1.5 No incidental, consequential or related costs such as costs for travelling,
transport, extra costs due to the installation in making the products
accessible, docking or cranes, loss of use, loss of income, loss of time, loss
ofprotsordamagesofanyotherpartsorgoodsshallbepayableunder
this condition 1.0 by HMI.
2.0 The warranty in condition 1.0 above does not cover Goods which in HMI’s
opinion have been damaged during transportation, installation or repair
orthroughabnormaluse,overload,carelessness,insufcientlubrication,
normal wear, use of spare parts other than genuine parts approved by HMI
or through any type of incorrect installation, abuse, misuse, accident or
through neglect or failure to follow instructions in the applicable owners
manual, maintenance instructions or installation instructions.
3.0 The warranty in condition 1.0 above will be void if You or your
representative, employees or contractors have taken abnormal risks or if
modicationshavebeenperformed,whichinthejudgementofHMIhave
caused or enhanced the damage, or if the security seals have been broken,
or settings altered, or if the Goods or any part thereof have been used in
violation of the law, or for an unintended purpose.
4.0 Thewarrantydoesnotcoverexpendableparts,suchasallkindsoflters,
belts, gaskets, rubber hoses, fuses, brushes, etc and lubricants.
5.0 The operation, maintenance and care of the Goods in accordance with the
instructions and requirements listed in the owners manual and the warranty
and service booklet provided by HMI is your responsibility. Records must be
keptofallmaintenanceservicesperformed,includingengineoilandlter
changes. This record of proper maintenance is required for the purpose of
determining warranty coverage on repairs and should be transferred to each
subsequent owner of the Goods.
6.0 All warranty claims must be advised to HMI prior to work being carried
out, and an authorisation number being allocated, to the distributors, dealer
WARRANTY TERMS AND CONDITIONS
INTRODUCTION
Your new Isuzu Marine Engine is covered by the HMI Warranty according
to the conditions and instructions contained below.
OWNER’S OBLIGATIONS
The operation, maintenance and care of your Isuzu Marine engine, in accordance
with the instructions and requirements listed in your Owner’s Manual and the
Isuzu Marine supplementary booklet, is your responsibility. Records should
be kept of all maintenance services performed, including engine oil and filter
changes. This record of correct maintenance is required for the purpose of
determining warranty coverage on repairs and should be transferred to each
subsequent owner.
Canal Boat Engine Range: It is also your responsibility to ensure that the warranty
card is filled in by yourself (self certification) and returned to HM Isuzu, as this
information forms part of the validation of your engine warranty.
The warranty card must be returned completed to ensure the warranty on
your engine is valid, this is the responsibility of the owner.
REPORT OF A DEFECT
It is the responsibility of the owner of any Isuzu product referred to herein to
report any defect to HMI, Boatbuilder, Distributor, Dealer, Workshop or Boatbuilder.
Such a report must be made as soon as possible and no later than fourteen (14)
days from the date when the user first observed the defect.
To Next Page
Loading...
Need help?
General
