Contents omitted in this manual
Though the following jobs are omitted in the explanation in this manual, they should be conducted
in actual work:
3) Jacking up and lifting
4) Cleaning and washing of removed parts as required
5) Visual inspection
(3) Definition of Terms
[NOTICE]: Instruction whose negligence is very likely to cause an accident. Always observe it.
Standard: Allowable range for inspection and adjustment.
Limit: The maximum or minimum value that must be satisfied during inspection or adjustment.
(4) Abbreviations
Abbreviation Meaning Abbreviation Meaning
Assy assembly T.D.C. top dead center
Sub-Assy sub-assembly B.D.C. bottom dead center
a.T.D.C after top dead center OS oversize
b.T.D.C before top dead center US undersize
STD Standard Min
-1
revolutions per minute
IN Intake PS Output (metric horsepower)
EX Exhaust T Bolt/nut tightening torque
To Previous Page
Loading...
