(3) Coolant Level Check
I) The coolant level must be between “FULL” and “LOW” marks
on the reserve tank.
Check and see that the level is correct.
When the coolant level is lower than the “LOW” mark, replenish
the reserve tank by the filler port, but when the reserve tank is
empty, replenish by the radiator filler port.
CAUTION:
When removing the radiator filler cap while the engine is
still hot, cover the cap with clothing, then turn it slowly
to gradually release the internal steam pressure. This will
prevent you from getting burnt with hot steam spouted
out from the filler port.
2) Use clean drinking water as coolant. When an anti-freeze
solution is required, keep to the specified mixing ratio.
(4) Radiator Cap Condition
After the replenishment of the coolant, install the radiator cap.
Make sure the cap is securely installed.
22
To Next Page
Loading...
