3. CHECK AND OPERATION AFTER THE
ENGINE START-UP
(1)
Warming-up Operation
Do the warming-up operation at 1000 min-l about ten minutes
after the engine has started.
As the lubrication for the entire engine systems will be done in
this warming-up, do not speed up and load it abruptly.
Particularly, observe this in cold season operation.
(2) Check after the Engine Start-up
Check the following items in the engine warming-up operation.
Engine oil pressure
Although the engine oil pressure gauge readings vary depending
on ambient temperature or a type of oil, the gauge registers
around 390 to 690 kPa (57 to 100 psi) in the warming-up.
In the oil pressure warning lamp type, make sure that the lamp
is off.
Charge condition
The charge condition is normal when once the ammeter
registers plus side greatly in the engine starting, then gradually
the meter registering will be minimized.
In the warning lamp type, make sure that the lamp is completely
off during the warming-up.
29
To Next Page
Loading...
