Cartridge
\
Set k filter wrench here
Fig. 23
Change procedure with spin-on type filter
1) Loosen the fuel filter turning it counterclockwise with a filter
wrench.
) With a rag wipe clean the fitting face on the upper cover, so that
new fuel filter can be seated properly.
) Lightly oil the O-ring. To reinstall, turn the filter assembly
clockwise carefully to prevent the fuel from spilling until the O-
ring is fitted against the sealing face of the filter cover.
Turn 2/3 turn further with the filter wrench.
2
3
(4)
Governor Control
Seals
As the governor (timing gear case) is precisely adjusted, most
of the controls are sealed, please do not break them. When the
adjustment is necessary, contact with your machine supply
source.
NOTICE: The manufacturer does not warrant the claim on the
engine with the broken governor sea/s.
52
To Next Page
Loading...
