isweek M9803R - Data Hold and Delay Functions

IntheDateHoldmode,the"    "annunciatorisdisp layedandthelastreadingisheldonthedisplay,the
beeperemitsatone.
Pressing      buttonwhenmultimeterisintheDateHoldmodecausesittoexitDateHoldandenterthe
Min/MaxRecordingHoldmode.
IntheMin/MaxRecordingHoldmode,press     b uttonstoptherecordingof readings,press
againtoresumerecording.
However, the multimeter is operating even though in Date Hold status, therefore, the buzzer sound is
comeoutwhenoccurthe over rangeorcontinuitymodes.Andtherangeisalso changedifitisinauto
range.
4.Delay Data Hold: DELAYHOLDButton
When button ispressedover eightsecond,totoggleinandout of the Date Holdmode,andthe
"    "annunciatorturnsonoroff.
5. Min/Max RecordingHold: MIN/MAXButton
Press button toentertheMin/MaxRecordingHoldmode.Theminimum,maximumvaluesarethen
resettothepresentinput,thereadingsarestoredin memory, and the " "annunciatorturnson.Push
the button to cycle through the minimum ( MIN ), the maximum ( MAX ), and present readings. The
" MIN
"
or " MAX"annunciatorturnsontoindicatewhatvalueisbeingdisplayed.
1-7