isweek M9803R - Safety Information; Compliance and Standards

8. Measuringvoltagethat exceeds the limitsofthemultimeter may damage the meter and exposethe
operatortoashockhazard.Alwaysrecognizethemetervoltagelimitsas statedonthefrontofthemeter.
9.  Neverapplymorethan500VDCbetweentheCOMjackandearthground.
10.Nevertouchavoltagesourcewhenthetestleadsarepluggedintoacurrentjack.
11. When testing for the presence of voltage or current, make sure the voltage or current ranges are
functioning correctly. Take a reading of a known voltage or current before assuming a zero reading
indicatesnocurrentorvoltage.
12.Donotattemptcalibrationorserviceunlesstrainedandanotherperson capableofrenderingfirstaid
andresuscitationispresent.
13.Remember:ThinkSafety,ActSafely.
Safety Information
The multimeter complies with Protection ClassⅡ, Overvoltage CATⅡ of the IEC61010-1(EN61010-1).
Pollution degree 2 in accordance with IEC-664 indoor use. If the equipment is used in a manner not
specified,theprotectionprovidedbytheequipmentmaybeimpaired.
Ⅴ
7.  Donotoperatethismultimeterinanexplosiveatmosphere(i.e.,in the presence of flammable gases
orfumes,vaporordust.)