isweek M9803R - DC;AC Amps Measurement Procedure

WARNING
Donotattempttomeasurecurrentsinhighenergycircuits.Usea
current clamp for measurement needs >10A. The 10A input
terminalisprotectedbyaF15A/250Vfastblowceramicfuse.
①.  TurntheSelectorto DC and AC Amps.
②.  Connecttheleadsasshown.
③.        isnotavailableinDCandACAmps;allotherbuttonscanbeused.
TheDCorACAmpsmeasurementischangedalternativelybyeachpressthebutton .
TheDCandACAmpsMeasurementisasfollows:
1.  InserttheblackandredtestleadsintotheCOM and A input terminals respectively.
2.  Turnoffordisconnectthecirc uittobemeasuredfromallpowersources,connectthemultimeterin
serieswiththeconductorinwhichthecurrenttobemeasuredflows.
3.  Turnonpowertothecircuitundertest.Notethereading,
4.  Aftercompletingthemeasurement,turnoffpowe rtothecircuitundertest,disconnectthetestleads
frommultimeter.
5. TheDCandACAmpsmeasurement are always fixed the range.
2-7