isweek M9803R - DC;AC Milliamps Measurement Procedure

WARNING
Do not attempt to measure currents in high energy circuits. The mA
inputterminalisprotectedby aF500mA/250Vfastblow fuse.
①.  TurntheSelectorto DC and AC Milliamps.
②.  Connecttheleadsasshown.
③.        isnotavailableinDCandACMilliamps;allotherbuttonscanbeused.
TheDCorACMilliampsmeasurementischangedalternativelybyeachpressthebutton      .
TheDCandACMilliampsMeasurementisasfollows:
1.  InserttheblackandredtestleadsintotheCOM and mA input terminals respectively.
2.  SelectthedesiredDCcurrentrangeorACcurrentrange.
3.  Turnoffordisconnectthecirc uittobemeasuredfromallpowersources,connectthemultimeterin
serieswiththeconductorinwhichthecurrenttobemeasuredflows.
4.  Turnonpowertothecircuitundertest.Notethereading,
5.  Aftercompletingthemeasurement,turnoffpowe rtothecircuitundertest,disconnectthetestleads
frommultimeter.
6.  TheDCandACMilliampsmeasurementarealwaysfixedtherange.
2-9