iSys V8.5 - Form Feed Stops before Desired Length; Form Feed Does Not Stop at Top-Of-Form Marks

To Next Page

To Previous Page

TROUBLESHOOTING

7-11V8.5e Rev 2.2.2002

Form feed stops before desired length

Possible Cause: The form feed length is too short. The form

feed stops before the paper sensor can read

the “top of form” mark.

Solution:

1. Adjust the FFLENGTH setting on the control panel as described

in Chapter 4, Page 4-10.

Form feed does not stop at top-of-form marks

Possible Cause: The top-of-form sensor is not reading the

marks.

Solution:

1. Contact your authorized service center.

VORSICHT: Bei der thermischen Plottertechnologie entstehen hohe

Temperaturen. Ungeeignete Medien oder falsche

Kontrasteinstellungen können den Druckkopf oder andere Bauteile

beschädigen und zu Verlust der Garantie führen. Auch können

Beschädigungen an den Medien entstehen.