CUSTOMER SERVICE
24
POWER SUPPLY
The receiving unit, for its operation, requires batteries
that run out by frequency of use of the appliance.
To prevent the replacement (about every two years),
the device can be connected to the power line con-
necting the power cord into the socket (1) present on
the receiving unit (2).
Connecting the appliance to the power line
n
etwork, the batteries (if present) are auto-
matically excluded and do not activate in the
event of sudden absence of the power supply.
W
ith the "wiring kit" installed, remove the
batteries from the receiver to avoid damage
due to spillage of acids.
To turn the unit in case of power cut simply
unplug the power cord from the socket (1)
and insert the batteries into the compartment.
MAINTENANCE
Clean only when it is switched off and com-
pletely cool.
- Cleaning the upholstery
Stainless steel, wipe with a soft, dry cloth. After this
first step you should use a degreaser such as aceto-
ne or vinegar diluted with water.
Painted metal, use a soft cloth dampened with
water.
For painted metal parts do not use alcohol,
paint thinner, gasoline, acetone or other
substances or abrasive cleaners.
If they use the Manufacturer assumes no liability
for any damages caused: tonal variations, scrat-
ches, etc..
- Cleaning the ceramic logs
Remove each item from the apparatus,
taking care not to damage it, if broken repla-
ce it immediately.
Clean each stick with a gentle stream of compressed
air, during cleaning operations to avoid a too close
contact with the workpiece to prevent any damage or
breakage.
Do not wash the logs with water or other
liquids to avoid compromising the integrity
and appearance.
- Cleaning the stones
Remove each item from the apparatus,
taking care not to damage it, if broken repla-
ce it immediately.
To Next Page
Loading...
