The appliance can be identified by means of:
- the packaging label
showing the name of the product, the code, the serial
number and the type of gas that can be used.
- The Technical Plate
showing the serial number, the model and the main
technical-performance data.
- The gas type plate
Showing the name of the gas for which the appliance
has been set and regulated. If the type of gas is
changed, this plate must be replaced with that of the
new gas!
Spare parts and/or technical jobs require the
exact identification of the associated model
of appliance.
Tampering with, removing or the absence of the
Technical Plate, etc. does not allow the exact
identification of the product, making any installa-
tion and maintenance job difficult.
T
his device is for decorative purposes.
Independent gas appliances for heating environ-
ments. They feature an atmospheric burner with
c
ombustion chamber TYPE B with open flame.
The combustion air is drawn directly from the room
where the appliance is installed.
-
Installation INSIDE
The discharge of combustion products may take
place in the chimney canalizzandoli with direct con-
nection to the asterno, size MIN Ø18cm.
The natural convective movement permits quick hea-
ting of the environments from when the appliance is
switched on.
- Installation OUTSIDE
If the unit is installed outdoors is not required to
achieve a chimney for exhaust fan (see chap.
Location of the unit).
An electronic board controls all the main functions of
the appliance and automatically interrupts the gas
supply in case of a fault.
The remote control features: appliance On/Off sup-
ply, heat output setting and operating condition reset
after a fault.
T
he device was built with materials and
components to withstand humidity and low
temperatures, nevertheless not be considered
fully water resistant.
The appliances are factory set, to operate
with Natural Gas, but are also available for
LPG (G30/G31).
T
his type of appliance can be transformed from
Natural Gas to LPG and vice versa with replacing
the burner.
The gas type and pressure used for operation are
shown on the technical data plate affixed to the
appliance.
Do not change the factory settings of the gas
control unit or receiver before installation.
The burner and pilot light are factory set by the
Manufacturer.
The appliance must be connected to the gas type
shown on the burner. Never ever connect a
Natural Gas burner to the LPG supply or vice
versa.
6
GENERAL
DESCRIPTION OF THE APPLIANCE
IDENTIFICATION
To Next Page
Loading...
