EasyManua.ls Logo

iTaste MVP3.0 - Safety Features and Protection Systems; Power Control and Safety Cutoffs; Device Protection Mechanisms

Default Icon
11 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2 . 5Ω
0.0W
V
4.0
2 . 5Ω
0.0W
V
Short Circuit/Atomizer Protecon:
Short Circuit/Atomizer Protecon protects the iTaste MVP3.0 Advanced Personal Vaporizer
against shorted atomizers and will stop the unit from funconing in unsafe condions.
The iTaste MVP3.0 features automac real-me atomizer Ohms detecon. If the resistance of
the atomizer is lower than 0.4, the Ohms bar will blink and the iTaste MVP3.0 will not power
on.
If there is a short circuit the iTaste MVP3.0 screen will display:
The LED light will power off. If there is a short circuit the MVP3.0 will not power on.
Over-Discharge Protecon:
The iTaste MVP3.0 Advanced Personal Vaporizer monitors the baery voltage and will
automacally power off when the baery over discharged.
0 . 2Ω
0.0W
V
4.0
0 . 0Ω
0.0W
V
4.0
9
8
ON/OFF baery switch:
Press the power buon three mes to turn on the iTaste MVP3.0. Once the iTaste MVP3.0
is on, hold down the power buon to acvate the atomizer. When the iTaste MVP3.0 is not in
use, press the power buon three mes in succession to power off the iTaste MVP3.0.
Always power off the iTaste MVP3.0 when it is not being used, or when it is going to be stored
in a pocket, bag or purse.
SAFETY:
15 second cutoff:
If the buon is held for 15 seconds or longer the iTaste MVP3.0 Advanced Personal
Vaporizer will stop firing unl the “ ” buon is released and pressed again.
Low Voltage Warning
The Red LED and Baery bar will connue blinking when the baery capacity is lower than 3.3V and
the iTaste MVP3.0 Advanced Personal Vaporizer will automacally power off.