iTaste MVP3.0 - Variable Voltage Mode and Usage Advice; Variable Voltage Mode Controls; Optimizing Low-Resistance and High-Wattage Vaping

Enter Variable Voltage Mode:
Press and hold the “-” buon and then the “ ” buon for 1 second to enter variable voltage
mode.
In variable voltage mode the iTaste MVP3.0 voltage can be adjusted from 3.0 to 9.0 volts in .1
volt increments by pressing the “+” or “-” buons.
Adjust Variable Voltage:
When the iTaste MVP3.0 is in variable voltage mode press the “+” or “-” buon one me and
then press it again to decrease the voltage. Hold the buon down to quickly increase or
decrease the set voltage.
The iTaste MVP3.0 voltage can be adjusted from 3.0 to 9.0 volts in .1 volts increments by
pressing the “+” or “-” buons. If the voltage is decreased below 3 volts it will cycle up to 9
Volts. If the voltage is increased from 9 Volts it will cycle down to 3 volts. Press the buon“ ”
to lock the set voltage and fire the iTaste MVP3.0.
Important: Explaining Low-Resistance / High Waage Vaping
To ensure you have the best possible vaping experience it is important to have a basic
understanding of waage, voltage and coil resistance. There is a range of standard coil
resistances: 2.1, 1.7, 1.4, 1.1, 0.8, 0.5 ohm etc and Rebuildable Atomizers or Drippers
(RBA/RDA) may even be lower. The iTaste MVP3.0 can fire between resistances of 2.5 to .4
ohm and you can clearly see the resistance of the aached clearomizer on the OLED screen.
We would suggest that for coil resistances of 1.7 – 2.1ohm you can begin with a seng of
8Was and then increase the Waage unl you find your perfect seng. For resistances of 0.5
you can try a seng of 25Was and increase the waage unl you find your perfect vaping
seng.
We would suggest that for coil resistances of 1.7 – 2.1ohm you can begin with a seng of 4.0
Volts and then increase the Voltage unl you find your perfect seng. For resistances of 0.5
you can try a seng of 5 Volts and increase the voltage unl you find your perfect vaping
seng.
If you have any quesons please contact your local Authorized Innokin Vendor.
Important: The iTaste MVP3.0 will only fire variable voltage OR variable waage depending on
the last seng chosen; it will not fire both. You must choose either Variable Voltage or
Variable Waage.
2 . 5Ω
0.0W
V
4.0
15
14