ITech IT6512A Programming Guide

4.9 Sequence Operation Command
SEQuence:EDIT
This command is used to select the list sequence to be edited.
Command syntax：SEQuence:EDIT<NR1>
parameter：1~10
inquiry syntax：SEQuence:EDIT?
Return parameter：1~10
SEQuence:STEP:ACTive
This command is used to select the steps to be activated of sequence.
Command syntax：SEQuence:STEP:ACTive<NR2>
parameter：0~1023
inquiry syntax：SEQuence:STEP:ACTive?
Return parameter：0~1023
SEQuence:VOLTage
This command is used to edit the voltage of specified step of the sequence.
Command syntax：SEQuence:VOLTage<NR1><,NRf>
unit：V
parameter:Parameter1 represents the number of step to be edited.Parameter2 is the voltage
(MIN~MAX).
Inquiry syntax：SEQuence:VOLTage? <NR1>
Return parameter：MIN~MAX
SEQuence:CURRent
This command is used to edit the current of specified step of a sequence file.
Command syntax：SEQuence:CURRent<NR1><,NRf>
parameter：Parameter1 represents the number of step to be edited.Parameter2 is the current
(MIN~MAX).

ITech IT6512A Specifications

General

Brand	ITech
Model	IT6512A
Category	Power Supply
Language	English