Function and Features
Copyright© Itech Electronics Co., Ltd. 46
af=2HZ
Standards for 12V system:
Curve should be selected based on actual test requirements. To create
waveform within 12V, follow the set standards as below:
Standards for 24V system:
How to recall “Starting Profile” waveform from menu (take 12V system as an
example):
1. Press [Shift]+ [I-set] (Function) to enter the menu operations.
2. Press Right direction key to select ISO16750-2, press [Enter].
3. Press Left/Right direction keys to select “Start”, press [Enter].
4. Press Right direction key to “On”, press [Enter].
5. Press Left/Right direction keys to select 12V/24V, and set the levels, press
[Enter].
6. VFD will display ISO-Start in the lower right corner.
7. Press [On/Off], turn on the output.
8. Press [Shift]+[Enter] (Trigger) to generate a trigger signal. The DC source will
output Short voltage drop waveform. The Trig indicating lamp will be lit and
To Next Page
Loading...
