Function and Features
Copyright © Itech Electronics Co., Ltd. 28
4. VFD display >TIME SEC，press to confirm，go to the next step,
you can also through button to select >TIME MIN time unit，press
to confirm.
5. VFD display >VSET 0.0, press number key to or through rotary
knob to set voltage，after that press to confirm.
6. VFD display ISET 0.00, press number key to or rotary knob to
set the single-step current, press to confirm.
7. VFD display SEC 0.100, press number key to or rotary knob to
set single-step delay time，press to confirm(range is 0.1-9999).
If you choose MIN for the 4
th
step, VFD will display MIN 0.100 for this step,
time range 0.1~9999min.
8. VFD display NEXT >YES，press to confirm.
9. Repeat the steps from 5) to 8) and set the four steps’ voltage/current and
delay time separately. When screen display NEXT>YES in the fourth step
edit process, please press to select NEXT >NO,press to
confirm.
10. VFD display REPET 1，press number key to or rotary knob to
set the repeat times，press to confirm.
11. VFD display SAVE >NO，press to confirm，in this circumstance,
the list file is not saved but can run for one time,or you can press button
to select >SAVE FILE0,saving the list test file in FILE0~FILE9，press
to confirm.You can recall the file in the following utilization.
12. If you do not save the list test file, VFD will display LIST EDIT;if you select
to save the test file,VFD will display SAVE DONE for three seconds,and
then display LIST EDITL.
Set List State
13. Press to select >LIST STATE item，press to confirm.
14. VFD display LIST >OFF, press to select >LIST >ON, press to
confirm.Now button will be lit.This indicates that list operation
function has been opened.
15. VFD display >LIST STATE，pressing button can quit the operation.
Run list file
16. Press button to open the output，press (Shift)+
（Trigger）to give a trigger signal.
Recall list file
17. If you have edited several list files,you can select LIST LOAD item to recall
the file you need.And then press to quit this operation.Press
button to open the output.Now you only need to press (Shift)+
(Trigger) to give a trigger signal,the list file can be ran.
Quit list file
To Next Page
Loading...
