ITech IT8512A+ Manual

21
Operation status register
7
6
5
4
3
2
1
0
NO USE
LOT
SENSE
LOCAL
OUT
REM
WTG
CAL
FOR
LOAD
ON
timer
status
Remote
sense
mode
LOCAL
button
state(0 is
disabled,1
is
enabled)
Load
input
state
remote
control
mode
Waitting
for a
trigger
signal
Load is in
calibration
mode
Enquire status register
0
RV
Reverse voltage
1
OV
Over voltage
2
OC
Over current
3
OP
Over power
4
OT
Over temperature
5
SV
remote sense wires are disconnected
6
CC
Constant current
7
CV
Constant voltage
8
CW
Constant power
9
CR
Constant resistance
10
PASS
Pass autotest
11
FAULT
fail to pass autotest
12
COMPLET
Complete autotest
Get the information of E-Load(rated max current,max voltage,min voltage,max
power,max resistance,min resistance). (01H)
1
st
byte
Start bit ( AAH )
2
th
byte
Address（0—31,0XFF)
3
th
byte
Command（01H）
From 4
th
to 7
th
byte
Rated max current (Lower bytes are in the former location, higher
bytes are in the later location)
From 8
th
to 11
th
byte
Rated max voltage(Lower bytes are in the former location, higher
bytes are in the later location)
From 12
th
to 15
th
byte
Rated min voltage (Lower bytes are in the former location, higher
bytes are in the later location)
From 16
th
to 19
th
byte
Rated max power(Lower bytes are in the former location, higher
bytes are in the later location)
From 20
th
to 23
th
byte
Rated max resistance(Lower bytes are in the former location, higher
bytes are in the later location)
From 24
th
to 25
th
byte
Rated min resistance (Lower bytes are in the former location, higher
bytes are in the later location)
26
th
byte
Sum code
30. Set/Enquire hardware OPP value (02H/03H)

ITech IT8512A+ Specifications

General

Brand	ITech
Model	IT8512A+
Category	Test Equipment
Language	English