EasyManua.ls Logo

iTechworld 2000W - Page 12

iTechworld 2000W
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Rear Panel Continued
B. DC Input Terminals
Warning: When connecting the DC input, pay close attention to the
polarity of the input. As a reverse polarity connection will cause
permanent damage to the inverter and void all warranty.
Warning: A fuse or DC circuit breaker is required; it must be installed
no further than 20cm from the positive terminal of your battery.
Failure to install a fuse or circuit breaker could cause a fire.
Please use the recommended fuse and minimum cable size as shown
in the table below. Please keep the DC input cables as short as
possible, if longer run cables are required, please use a larger cable.
Recommended Cable Size and Fuse Rating.
Model
Cable Size
Fuse/ Circuit Breaker
1000W
Inverter
10mm² for
lengths <1M
175A
2000W
Inverter
25mm² for
lengths <1M
250A
3000W
Inverter
35mm² for
lengths <1M
450A

Related product manuals