iTechworld ITECH100S - Wiring Configurations; Parallel Wiring for Load; Parallel Wiring for Charging

When creating a bank of iTECH100S batteries, all the
batteries must be of the same voltage. When drawing a
load from the bank it should be split as follows:
2 battery bank
Positive to battery number 1
Negative to battery number 2
3 battery bank
Positive to battery number 1
Negative to battery number 3
4 battery bank
Positive to battery number 1
Negative to battery number 4
And so on and so forth.
The charging system should be connected to the iTECH100S
battery bank in the same manner.
WIRING
USER GUIDE