Itek I60017 - Troubleshooting

10
CUSTOMER SUPPORT TEAM: +44 (0) 333 220 6058
Volume: Use the volume + and – buttons
on the remote to adjust the
volume output.
Open/Close: Press to eject a CD from the
disc drive.
Play/Pause: Press to play, press again to
pause playback.
Stop: Press to stop playback.
Skip forward: Press to skip to the next track.
Skip
backwards: Press to skip back to the
previous track.
Repeat: For use with the CD function.
Whilst a CD is playing, press
once to repeat a track.
Prog: When the CD is stopped, press
to program tracks.
TROUBLESHOOTING
The following checks will assist in the correction
of most problems which you may encounter
with your set. Before going through the check
list below, rst check the following points:
The power cord must be connected rmly.
Should any problem persist after you have
made these checks consult your nearest
dealer.
Problem Possible Causes and
Solutions
The jukebox has
no power.
Ensure that the adaptor has
been properly connected.
Check that the jukebox has
been switched on at the mains
power supply.
The jukebox
is not playing
sound.
Check that the volume level
is set at an audible level and
adjust accordingly.
Unable to pair
a Bluetooth
device.
Check if the device is
compatible with the jukebox
and ensure the Bluetooth
function on your device is
switched on.
The jukebox may not be set
to the correct mode. Press
the source button to select
the Bluetooth function – when
the Bluetooth indicator light is
ashing, search for ‘I60017’ on
your device.
The remote
control is not
working.
The battery may be exhausted.
Replace with a new battery.
Make sure the remote is
pointed at the jukebox during
use.
The sound is
distorted.
The volume or bass level
may be too high. Reduce the
volume and/or bass levels to
increase sound clarity.
Note: The normal function of the product
may be disturbed by strong Electro-Magnetic
Interference. If so, simply reset the product
to resume normal operation. If the issue
continues, please move the product to another
location.