24
The emergency buttons are active in all security levels. The system recognizes
the emergency buttons as sensors (see Table 5).
■ To activate a police, fire, or auxiliary/medical alarm
from the panel:
Press and hold both emergency buttons at the same time, for at least 3 seconds.
or– Press both emergency buttons twice within 3 seconds.
or– Press
COMMAND
, then immediately press both emergency buttons at the
same time.
The interior and exterior sirens and the panel sound the appropriate alarm. Exte-
rior sirens do not sound for auxiliary/medical alarms.
■
To activate a police or auxiliary/medical alarm from a
Handheld Touchpad:
Press and hold the appropriate emergency button for at least 3 seconds.
The interior and exterior sirens and the panel sound the appropriate alarm. Exte-
rior sirens do not sound for auxiliary/medical alarms.
NOTE: The Handheld Touchpad only has a POLICE emergency
button.
■ To activate an alarm from a Keychain Touchpad:
Simultaneously press the Arm and Disarm buttons until the light blinks to acti-
vate an alarm type set by your security consultant.
The interior and exterior sirens and the panel sound the appropriate alarm. Exte-
rior sirens do not sound for auxiliary/medical alarms.
■
To cancel a police, fire, or auxiliary/medical alarm:
Enter
ACCESS CODE + 1
from the panel or a touchpad. Sirens are silenced, and
the panel announces,
Sensor [sensor #] [alarm type] Alarm memory, Alarm
system is OFF. See Table 5 for the appropriate sensor number.
Table 5
. Emergency Button Sensor Numbers
Emergency
Button
Sensor Number
POLICE 81
FIRE 80
AUXILIARY 82
To Next Page
Loading...
