ITI Commander 2000 - Checking the System Status (STATUS)

35
■ To turn controlled lights on or off from a Keychain Touchpad:
Press the Light button and hold until the light blinks.
The Panel announces,
On or Off. Controlled lights turn on or off, depending on the
current setting.
Checking the System Status (STATUS)
Whenever you disarm the system or experience system problems, check the system’s sta-
tus. The panel may notify you of the following conditions:
 Sensors that are open or have covers off
 Sensors with low batteries
 Sensors that are bypassed
 Condition of AC power
 Condition of backup batteries
 Sensor alarms that occurred during the arming period
 Sensors experiencing communication failure
■
To check system status:
Press
STATUS.
The panel and interior sirens sound the appropriate number of arming level beeps for
the current security level, and the panel announces the status of the system.
NOTE: If a sensor is open, the system announces the open sensor number
instead of announcing the complete system status. The status of
the system battery and AC power are announced only if there is a
failure.
STATUS