ITL SOLIS 20 - Inspection Procedure

C 7.0 INSPECTION PROCEDURE
A- CLUTCH DISC
B- CLUTCH COVER
A) CLUTCH DISC
CHECKING
• Hardened facing or oil on the facing.
• Use sand paper to rectify minor hardening.
• Fatigued torsion springs.
• Loose facing rivets.
• Worn Clutch disc.
Note : Measure the depth of the rivet head of disc.
Allowable limit up to 1.6 mm (FOR ALL SOLIS-III MODELS)
B) CLUTCH COVER
CHECKING
Fatigue and breakage of the diaphragm spring and breakage of the cover.
Streaks, cracks and discoloring of the pressure plate in contact with the disk.
Note : Minor straks and discoloring can be repained by polishing with send paper.
SERVICE MANUAL
C-5
ITL