SERVICE MANUAL
E-11
Insert the shaft (33) in the fork (16).
Note: align the pin hole in the shaft (33) to the hole in the fork (16).
Insert the fastening pin (31) with a punch and a hammer.
Apply prescribed sealant on the plug thread (32).
Assemble the plug (32) and tighten it to the prescribed torque.
See: sec. C.4.
Insert the bearing (12) into the transmission housing with the special tool
CA715622 and a hammer.
See: sec. E.1. (4WD mechanical drop box).
FIG. 12
FIG. 13
FIG. 14
FIG. 15
ITL
To Next Page
Loading...