ITL SOLIS 20 - Page 157

SERVICE MANUAL
E-24
D.3.2 Assembly
1. Clean all contact surfaces of cover (7) with care.
2. Apply prescribed sealing.
See: sec. C.4.
3. Assemble cover (7) to the gear box (1).
See: fig.3.
4.
Note: cover (7) correct assembly.
See: fig.4.
Fig.4
5. Assemble screws (6) to the prescribed torque.
See: sec. C.4.
6. Clean all contact surfaces of the lever assy (3) with care.
7. Apply prescribed sealing.
See: sec. C.4.
8. Assemble lever assy (3) on gear box (1).
Note: check the correct assembly of centring pins (2) and gear clutch lever.
9. Assemble screws (4) to the requested torque.
See: sec. C.4.
ITL