SERVICE MANUAL
B-46
Step 62
(1) Screw 8 Studs in front face of crank case
6 studs of M16*59
2 studs of M16*64
(and fit 2 locating hollow dowel in case of SGI front cover.)
And 2 locating dowel pins in case of CI front Cover
10 bolts M10*50
1 bolt M10*55
3cap head screw
11 Spring washers B-10
Step 63
Clean front cover properly . Place the front cover gasket and front cover
on the locating dowels and tighten with following fasteners
For SGI Front Cover (Bigger)
8 NUTS M16x2
8 Spring washer B16
1 Bolts 10x55
4 Bolts 10x50
3 cap head screw
5 Spring washer B-10
FOR CI front cover (Small)
ITL
To Next Page
Loading...