SET UP AND OPERATION
Page 22
Assembly
Always wear gloves, eye protection, and appropriate safety gear when working with pullers.
1. Remove iTOOLco Cannon 12K from the shipping crate.
2. Insert 5 conduit adapters into the base unit.
3. If necessary, install axles and wheels onto base.
4. iTOOLco Cannon 12K is designed to be used with a 20 amp, 6 speed coring motor.
5. Plug in the foot switch to the 100 volt power supply.
6. Set the desired speed.
Step 1 Step 2
Step 3 Step 4
Step 5 Step 6
To Next Page
Loading...