www.itrackgpstrackers.com 7
6.8.3. Alternatively you can call the tracker 10 times continuously and get its position, then it will save the cell
phone number as the authorised number automatically. It will reply “add master ok”.
6.8.4. Delete authorisation: Send SMS “noadmin+password+space+authorised number” to delete the authorised
number.
6.8.5. If you want to track the target when it enters into another country, you must add the country code before
the cell phone number. You should authorise your number in international format as follows:
“admin123456 00447989123456” to tracker to set 07989123456 as an authorised number. Please make
sure you don’t use a ‘+’ sign.
6.8. Request for OBD data by SMS
Send SMS command “obdmsg+password” to the tracking device. The tracker will reply with the following:
(Note: Not all vehicles will send data for every variable listed)
863070010034246 15 digit IMEI Number
T: 05/21/13 15:25:50 Time
ODO: Accumulative mileage
FLI: Remaining fuel
AF: Average Fuel
Dtime: Driving time
speed: Speed
Pload: Power load
TEMP: Water temperature
ATP: Throttle percentage
RPM: Engine speed
BAT : Battery voltage
DTC: Diagnostic trouble code
For “Cumulative mileage, remaining fuel, average fuel consumption”, tracker will identify intelligently and display
it if vehicle protocol supports it.
If the vehicle supports “cumulative mileage” then you can set the travelled mileage. If it supports “remaining
fuel”, then you can set the fuel tank volume.
The “average fuel” means the average fuel consumption of 100km; it will be showed only after driving at least
10km.
6.9. Set Mileage
Send SMS command "ODO+password+space+100000" Mileage units are kilometers and tracker will reply "Set
ODO ok!". The device will automatically add this travelled mileage in the value of cumulative mileage.
6.10. Set Fuel Tank volume
Send SMS command "tank+password+space+60" The fuel tank volume is in liters（L). Tracker will reply "Set
To Next Page
Loading...