To Next PageTo Next Page
Need help?Do you have a question about the ITRON Delta Series and is the answer not in the manual?
General| Display | LCD with backlight |
|---|---|
| Operating Temperature | -10°C to +55°C |
| Storage Temperature | -25°C to +70°C |
| Current Range | 5A to 100A (direct connection), higher with CTs |
| Frequency Range | 45Hz to 65Hz |
| Communication Interface | RS485 |
Confirmation of compliance with the Pressure Equipment Directive (PED) including module B+D for Category IV.
Statement of compliance with the Electromagnetic Compatibility (EMC) Directive.
Declaration of conformity with the ATEX Directive for equipment used in potentially explosive atmospheres.
Confirmation of compliance with the Measuring Instruments Directive (MID).
Statement of compliance with the Restriction of Hazardous Substances (RoHS) Directive.
Instructions for storing the meter in a clean, dry environment to maintain its condition before installation.
Guidelines for safely lifting and moving the meter, emphasizing proper support to prevent damage.
Key considerations and checks for proper installation, including visual inspection and pipe alignment.
Recommendations for upstream gas filtration to ensure meter accuracy and longevity.
Guidance on selecting and applying the correct lubricant for optimal meter performance.
Information on pulse transmitters, anti-tampering switches, and sensors, including ATEX compliance.
Details on a filter integrated into the gasket for protecting the meter from upstream particles.
Usage instructions for an optional external cartridge for severe environmental conditions.
Advice on using flow limiters to protect the meter from over-flow or pressure pulses.
Essential checks and procedures to follow before and after pressurizing the meter for initial operation.
Step-by-step instructions for safely starting up the meter with an existing bypass system.
Procedures for initiating the meter's operation when no bypass line is present.
Specific installation and start-up precautions for meters installed downstream of a regulator.
Routine checks, lubricant level monitoring, and cleaning procedures for meter upkeep.
Care instructions for auxiliary components such as LF/HF transmitters and filters.
