ITRON ERT 50W - User Manual

Water Solutions
Installing 40W and 50W ERT
®
Modules
Revision B

ITRON ERT 50W Specifications

General

Power	50W
Communication Protocol	Modbus RTU
Enclosure Rating	IP65
Frequency	50Hz
Input Voltage	230V AC
Input Frequency	50Hz
Humidity	5% to 95% non-condensing

Summary

SECTION 1. INTRODUCTION

1.1 Installation Procedures

Procedures for 40W and 50W ERT modules are identical.

1.4 Meter-ERT Compatibility

Lists ERT module part numbers and compatible meters for correct installation.

1.5 ERT Module Configurations

Illustrates installation configurations for various ERT modules and meters.

1.7 Tools and Materials You Must Supply

Lists necessary tools and materials for ERT module installation.

SECTION 2. INSTALLING THE BADGER DIRECT-MOUNT

2.1 Installation Procedures

Step-by-step guide for installing a Badger direct-mount ERT module.

SECTION 3. INSTALLING THE AMCO (ABB) SCANCODER, InVISION, OR DIGITAL DIRECT-MOUNT

3-1 Bracket Preparation

Prepare the ERT module mounting bracket by pushing out a hollow pin.

SECTION 4. INSTALLING THE SCHLUMBERGER ARB V OR PROREAD REGISTER-MOUNT

4-1 Enclosure Cover Removal

Remove the wire terminal enclosure cover from the register.

SECTION 5. INSTALLING THE SENSUS ECR OR ICE REGISTER MOUNT

5-1 Cable Entrance Cover Removal

Remove the cable entrance cover from the meter register.

SECTION 6. INSTALLING A REMOTE MOUNT

6-1 Wire Preparation

Prepare wires by stripping outer insulation and individual wire insulation.

SECTION 7. PIPE MOUNTS (AND REGISTER MOUNTS REQUIRING A BAND CLAMP)

7-1 Bracket and Band Clamp Acquisition

Obtain the necessary bracket and band clamp from the installation kit.