ITT Hydrovar Operating Instructions

Operating Instruction
13
www.hydrovar.com
Front label
LED Signal Stop-Button Start-Button
Error code Decrease Increase
5 Status signal and required value adjustment
After connecting the power supply to the Hydrovar- Watercooled the 1
st
LED is switched
on.
To start the unit, press the (+)-button.
Fast blinking of LED 1 Pump is running
Slow blinking of LED 1 Required pressure is reached and the unit is in standby mode
To stop the unit, press the (-)-button.
Auto Start Function – Memory Function:
HVW in operation - after a power supply failure – HVW will start automatically again
HVW in standby – after power supply failure – HVW will remain in standby mode, if the
required pressure is available
- after pressure is down – HVW will start automatically.
If the unit has been stopped - stop-button has been pressed - before the power supply failure,
the Hydrovar- Watercooled is also stopped after return of the supply power.
z
Bright
{
Dark
}
Slow blinking

Fast blinking
Display of the system pressure
Description of the LED Signal

ITT Hydrovar Specifications

General

Brand	ITT
Model	Hydrovar
Category	Inverter
Language	English